Version Notes 

MASTERLIGN 1.18

• Sleep Mode available only with Hardware version 3. You can check your hardware version with F94. 
  Previous hardware versions cannot be retrofitted to benefit from this new option.
  
• Save Function
  If you are working on a file and you press SAVE, the Masterlign automatically assigns the next available file number.
  But if you press SAVE again while in the same file then the Masterlign displays and flashes the current file number so that you
  can append your changes to the open file. If you do not wish to append a change then you must overwrite the suggested number.
  You can compare the new Masterlign Save Function to the PC functions SAVE AS and SAVE.
  
• Review of soft foot values possible without measurement: 

1. Press the soft foot key
2. Press ENT (If the beam is within range, the existing soft foot values will immediately be displayed and 
   can be cycled through with the left/right arrow keys.) Otherwise (in other words if beam is END or OFF),
3. Press ENT again. Cycle through soft foot values with the arrow key